Topics Map > IT Services > Device Support

ResNet - Using the Network Switch

How to set up the network switch to allow up to 4 devices to be connected via ethernet.

How to Set Up the Network Switch

This is NOT a wireless router. Devices will need to be connected via ethernet cable to the switch.
  1. Plug the power cable into your switch and into the wall, the green power light should be on. 
  2. Connect the orange ethernet cable to and port on the back of the switch and one of the following dependent on residence hall:
    1. NO Wireless Access Point - Scotts, Gruenhagen, Evans, Stewart, Donner, Webster: Plug the other end of the orange ethernet cable into the black port on the wall.
    2. Wireless Access Point - Scotts, Gruenhagen, Evans, Stewart, Donner, Webster: Plug the other end of the orange ethernet cable into any other port but black on the wireless access point.
    3. Taylor, Fletcher, Horizon: Plug the other end of the orange ethernet cable into an ACTIVE orange port on the wall.
  3. Connect all other devices via ethernet cable to the network switch.




Keywords:network switch, ethernet, residence halls   Doc ID:100158
Owner:Liz B.Group:UW Oshkosh
Created:2020-04-06 16:04 CDTUpdated:2020-04-06 16:04 CDT
Sites:UW Oshkosh
Feedback:  0   0